User Manual Q&AAnswer
Jul 16, 2024 - 04:41 AM
If your Metabo HPT KC18DEXQB Driver Drill Combo Kit is not powering on, there are a few possible causes and troubleshooting steps you can take:
1. Ensure the batteries are securely inserted and properly locked in place. Sometimes, the batteries may not make proper contact if they are not fully inserted or locked in place. Reinsert the batteries if necessary.
2. Check the battery charge using the fuel gauge indicators on the batteries. If the batteries are low on charge, they may not have enough power to turn on the tools. Recharge the batteries using the provided charger.
3. Verify that the power switch on the tools is in the "on" position. Sometimes, the power switch may accidentally be turned off, preventing the tools from powering on. Turn on the power switch and try using the tools again.
4. If the batteries fail to hold a charge or show signs of damage, they may be faulty. In this case, it is recommended to contact the manufacturer for assistance or replacements.
By following these troubleshooting steps, you should be able to determine the cause of the issue and resolve it accordingly. If the problem persists, it is advisable to reach out to Metabo HPT's customer service for further support.
Add New Comment