User Manual Q&AAnswer
Jul 09, 2024 - 05:00 AM
To replace the batteries in the WdtPro C1200 LED Bright Flashlight, please follow these steps:
1. Ensure that the flashlight is turned off and the power button is not pressed.
2. Locate the battery compartment on the flashlight. It is usually located at the bottom or near the handle.
3. Open the battery compartment by twisting or sliding the cover in the designated direction. Some flashlights may have a latch or button to release the cover.
4. Remove the old batteries from the compartment. Pay attention to the polarity markings (+ and -) on the battery compartment and the batteries themselves.
5. Insert the new batteries into the compartment, aligning the polarity markings correctly. Make sure the positive (+) end of the batteries is facing the appropriate direction.
6. Close the battery compartment by securing the cover back in place. Ensure that it is properly sealed to prevent any water or dust from entering.
7. Test the flashlight by pressing the power button. If the batteries are inserted correctly, the flashlight should turn on.
Please note that the WdtPro C1200 LED Bright Flashlight requires 16 AAA batteries, which are not included with the product. Make sure to have the necessary batteries on hand before attempting to replace them.
Add New Comment