User Manual Q&AAnswer
Jul 04, 2024 - 12:06 AM
To charge your phone using the Eton ARCCR100R-SNG Clip-On Flashlight, follow these steps:
1. Make sure the flashlight is fully charged. If it needs to be charged, use the USB wire that came with it to connect it to a power source and charge it until it's fully charged.
2. Locate the built-in USB charging port on the flashlight. It is usually located on the side or bottom of the flashlight.
3. Connect your phone to the flashlight's USB port using a standard USB cable. Plug one end of the USB cable into the USB port on the flashlight and the other end into your phone's charging port.
4. Once the phone is connected, turn on the flashlight by pressing the power button or switch. This will activate the charging function.
5. Keep cranking the flashlight for one minute to generate power for charging your phone. The hand crank should be turned clockwise.
6. Monitor your phone's battery level to ensure it is charging. The charging speed may vary depending on the phone and the remaining battery level.
7. Once your phone is charged to the desired level, disconnect it from the flashlight by removing the USB cable.
Note: It's important to keep in mind that the Eton ARCCR100R-SNG Clip-On Flashlight is designed to provide emergency charging for phones and other devices. The charging capacity may be limited, and it is recommended to use it as a backup option rather than a primary charging source.
Add New Comment