User Manual Q&AAnswer
Jun 21, 2024 - 02:52 AM
To change the color and brightness of the Lithomy RGB109 Dimmable Floor Lamp, you have two options: using the remote control or the touch panel on the lamp itself. Here are the step-by-step instructions for both methods:
Using the Remote Control:
1. Make sure the lamp is plugged in and turned on.
2. Point the remote control towards the lamp.
3. Press the "Power" button on the remote control to turn on the lamp.
4. Use the arrow buttons to navigate through the color options.
5. Press the "Brightness" button to adjust the brightness level.
6. Experiment with different colors and brightness levels until you find the desired setting.
7. To turn off the lamp, press the "Power" button again.
Using the Touch Panel on the Lamp:
1. Make sure the lamp is plugged in and turned on.
2. Locate the touch panel on the lamp, usually located near the base or on the pole.
3. Tap the touch panel to turn on the lamp.
4. Swipe left or right on the touch panel to change the color.
5. Swipe up or down on the touch panel to adjust the brightness level.
6. Experiment with different colors and brightness levels until you find the desired setting.
7. To turn off the lamp, tap the touch panel again.
Note: The specific instructions for changing colors and brightness may vary slightly depending on the model and firmware version of the lamp. Please refer to the user manual that came with your lamp for detailed instructions specific to your model.
Add New Comment