User Manual Q&AAnswer
Jun 10, 2024 - 04:56 AM
To use the NURSAL AS1080 TENS EMS Muscle Stimulator, follow these steps:
1. Prepare the pads: Connect 2 pads to the cord by snapping them on. Use the 1/4 wire and make sure to use 1 positive + 1 negative wire. Remove the protective film.
2. Place the pads: Place the pads where you want the massager to impact, over or near the injured area of the body. Ensure that your skin is free from any dirt, oil, or lotion.
3. Connect the wires: Connect 2 or 4 pads to both wires (A/B channel). Place all connected pads on your skin at the same time for additional relief.
4. Set the timer: Turn on the device by pressing the ON/OFF button. Press the "T" button to adjust the time. Set the time from 10 to 60 minutes.
5. Choose a mode: There are 6 main modes with 4 built-in modes each. Press the "M" button for 2 seconds to switch between the main modes. Press the "M" button quickly to choose built-in modes for each main mode.
6. Adjust the intensity: Once you select a mode, press the "+/-" button to gradually increase or decrease the intensity. The default strength is the lowest strength set by each selected mode.
7. A/B channel switching: Short press the round center button to switch from A channel to B channel. Repeat steps 5 and 6 to operate the mode and intensity of the B channel.
8. Lock the screen: After setting both A and B channels, long-press the round center button for 3 seconds to lock the screen. This function is designed to avoid mistouch.
9. Shut off the appliance: The TENS unit will shut off automatically after the set time.
Please refer to the NURSAL AS1080 TENS EMS Muscle Stimulator User Manual for more detailed instructions and illustrations.
Add New Comment