User Manual Q&AAnswer
May 30, 2024 - 01:38 AM
To replace the batteries in the Reyke 80dB+ RF Item Locator Key Finder, please follow these steps:
1. Locate the receiver that needs a battery replacement. Each receiver requires 4 x CR2032 batteries.
2. Use a small screwdriver or similar tool to remove the xxxx on the back of the receiver.
3. Open the battery compartment by sliding the cover off.
4. Take out the old batteries and dispose of them properly.
5. Insert 4 new CR2032 batteries into the battery compartment, ensuring the correct polarity (+/-) alignment.
6. Slide the battery compartment cover back into place.
7. Secure the xxxx on the back of the receiver to close the battery compartment.
8. Repeat these steps for any other receivers that require battery replacement.
Please refer to the user manual for visual instructions and additional information on battery replacement.
Note: The transmitter of the Reyke 80dB+ RF Item Locator Key Finder requires 2 x AAA, 1.5V batteries. If you need to replace the batteries in the transmitter, follow the same steps mentioned above, but ensure you use AAA batteries instead of CR2032 batteries.
If you encounter any difficulties or have further questions, please refer to the user manual or contact Reyke Technologies at support@reyke.com or 1-800-REYKE-HELP for assistance.
Add New Comment