User Manual Q&AAnswer
May 30, 2024 - 12:46 AM
Installing the MEDAS 3434 GPH Submersible Clean-Dirty Water Pump is a straightforward process. Here are the step-by-step instructions:
1. Ensure that the pump is compatible with the type of water and the intended application.
2. Submerge the pump in the water, making sure it is fully submerged to avoid damage. The pump can operate in water levels as low as 3 feet.
3. Connect the appropriate hose or pipe to the pump outlet. The pump comes with a 1-inch NPT discharge, and a GHT 3/4" fitting that fits a garden hose. It also includes a hose adapter that fits 1-1/2, 1-1/4, or 1-inch hoses.
4. Plug the pump into a power source with the correct voltage. The MEDAS 3434 GPH Submersible Clean-Dirty Water Pump requires a 110-volt power source.
5. Turn on the pump and adjust the flow rate as needed. The pump features a high-capacity discharge and a maximum flow rate of 3434 gallons per hour (GPH).
6. Monitor the pump during operation to ensure proper function. If you notice any unusual noise, vibration, or leakage, refer to the troubleshooting section in the user manual.
7. When finished, turn off the pump and disconnect it from the power source.
Please refer to the user manual for additional information and safety precautions.
Add New Comment