User Manual Q&AAnswer
May 20, 2024 - 11:47 PM
To pair the outdoor sensor with the U-UNNI UN0582 Digital Wireless Thermometer indoor unit, please follow these steps:
1. Insert batteries: Insert 2x AA batteries into the wireless sensor, ensuring the correct polarity. The red LED indicator on the sensor will flash while it is transmitting.
2. Open battery compartment: Open the battery compartment of the weather station and insert 3x AAA batteries in the correct polarity. Close the battery compartment.
3. Plug in USB cord: Plug in the USB cord to the weather station. This will keep the backlight on and allow you to adjust the brightness.
4. Start pairing mode: Once the weather station is turned on (either by batteries or USB cord), it will start receiving pairing RF signals from the outdoor sensor for 3 minutes. You can press the CH button on the weather station to match the correct outdoor sensor.
5. Automatic pairing: In most cases, the outdoor sensor will connect with the weather station automatically. If it fails to connect, follow the next steps.
6. Manual pairing: Make sure you set different channels for the sensor (1-3). You can set the channel by pulling the stick near the batteries. On the weather station, press the CH button once to adjust to the corresponding channel. Then, long press the CH button to search for the signal from the outdoor sensor.
7. Wait for connection: The sensor receiving icon on the weather station will flash while searching for the signal. Once the sensor is connected, the icon will become stable.
8. Automatic search: The weather station will automatically search for the signal every 3 minutes every hour until it is connected.
Note: If you need to add additional wireless outdoor sensors, you will need to set different channels for each sensor and follow the same pairing process.
For more detailed instructions and troubleshooting tips, please refer to the U-UNNI UN0582 Digital Wireless Thermometer operating instructions manual.
Add New Comment