User Manual Q&AAnswer
May 06, 2024 - 07:43 AM
To install and pair the tado Wireless Smart Thermostat Starter Kit V3+ with Hot Water Control, please follow the instructions below:
1. Install the Internet-Bridge:
- Connect the Internet Bridge to your router using the included 5V power adapter.
- Press and hold the pairing button on the Internet Bridge until the pairing LED starts blinking.
2. Pair the Wireless Temperature Sensor:
- Remove the battery protection strip from the Wireless Temperature Sensor.
- Press the button on the sensor for 3 seconds to start the pairing process.
- Pairing may take up to 2 minutes.
- A static icon will indicate successful pairing. If pairing fails (E0), ensure that the distance between the devices is approximately 3 meters and try pairing again.
3. Replace the room thermostat:
- Caution: Turn OFF the power before wiring.
- If there is a wired room thermostat installed in the zone intended to be controlled by the Wireless Receiver, decommission it by bridging the control wires and insulating the other wires with the included 2-terminal connector blocks as shown in the images.
- Once tado° is installed, the Wireless Receiver will be the only device that controls the heating system.
4. Wire the Wireless Receiver:
- Caution: Turn OFF the power before wiring.
- Mount the Wireless Receiver to the wall before wiring.
- Use the included strain reliefs and position them on the outer insulation layer of the cable.
- Follow the wiring instructions provided in the manual based on your heating system configuration (S-Plan, Y-Plan, or Combi Boiler).
5. Pair the Wireless Receiver:
- Put the cover on the Wireless Receiver.
- Turn the power back ON and wait for 30 seconds.
- Press and hold the main button above the signal icon on the Wireless Receiver for 3 seconds to start the pairing process.
- A solid light indicates successful pairing.
6. Configuration:
- Configuration is only required if tado° is wired to a combi boiler or a gravity-fed system.
- Press both test buttons on the Wireless Receiver at the same time for 5 seconds until the colored power LED shows the current configuration.
- Press the heating TEST button to switch between configurations and wait 5 seconds to confirm the selection.
- The LED will blink to indicate that the selection is being saved, and then it will stay solid for 20 seconds in the color of the selected configuration.
For more detailed instructions and troubleshooting information, please refer to the tado Wireless Smart Thermostat Starter Kit V3+ with Hot Water Control Instruction Manual provided by the manufacturer.
Add New Comment