User Manual Q&AAnswer
May 04, 2024 - 01:55 AM
To program the preset buttons on the remote control, follow these steps:
1. Adjust the bed to the desired position.
2. Press and hold the desired preset button (1, 2, or 3) for approximately three seconds until the LED lights start flashing.
3. Release the preset button and within one second, press the same preset button again.
4. The LED lights will stop flashing and the selected button is updated to the new position.
Note: The three preset buttons are pre-programmed with the manufacturer's suggested bed positions. If you want to customize the positions, follow the steps above to program the desired positions.
Please refer to the "Custom Programming Preset Buttons" section in the instruction manual for more detailed instructions and illustrations (Image D).
Add New Comment