How do I set up the Tenda O3 5km Outdoor Point to Point CPE for CCTV surveillance or point-to-point data transmiss (Tenda O3 5km Outdoor Point to Point CPE Installation Guide)

Answer

manuals.plus

Mar 29, 2024 - 01:59 AM

To set up the Tenda O3 CPE for CCTV surveillance or point-to-point data transmission, you can follow the steps below:

1. Set up the Devices in AP + Client Mode:
- Method 1: Automatic Bridging (Recommended)
- Place the two devices next to each other and power them on.
- Wait for the devices to automatically connect and bridge with each other.
- Once the LED indicators on one device are solid on and the other device's indicators are blinking, the bridging is successful.
- Method 2: Set up the Device Using Web UI
- Connect your computer to CPE 1 using an Ethernet cable.
- Access the web UI of CPE 1 by entering 192.168.2.1 in a web browser.
- Set CPE 1 to AP mode and configure the SSID, security mode, and key.
- Connect your computer to CPE 2 and access its web UI.
- Set CPE 2 to Client mode and select the SSID of CPE 1, enter the WiFi password, and set the IP address.
- Save the settings and wait for the devices to bridge.

2. Install the Devices:
- For CCTV Surveillance or Point-to-Point Data Transmission:
- Connect the device with solid LED indicators (transmitter in AP mode) to the switch connecting to a network video recorder (NVR).
- Connect the device with blinking LED indicators (receiver in Client mode) to the switch connecting to a monitoring IP camera.
- Adjust the devices' direction or location until all LED indicators are lit.
- Use the pole mounting straps to attach the devices to the poles.

Please refer to the Tenda O3 5km Outdoor Point to Point CPE Installation Guide for more detailed instructions and illustrations.