User Manual Q&AAnswer
Feb 28, 2024 - 02:36 AM
To connect the Thermostat Salus to your boiler, you will need to install the RF boiler control. Here are the step-by-step instructions:
1. Remove the front panel from your boiler.
2. Do not remove the boiler loop.
3. Replace the front panel, ensuring a good seal is made.
4. Connect the electrical plug of the RF boiler control.
5. Pull out the mechanical timer from the boiler.
6. Push fit the boiler control into the housing.
7. Power up the boiler and check for correct operation.
Please note that these instructions are a general guide. It is always recommended to refer to the specific installation manual provided with your Thermostat Salus for detailed instructions and any additional steps that may be required for your specific boiler model.
Add New Comment