User Manual Q&AAnswer
Feb 21, 2024 - 10:25 PM
To install the Maytag front load washer, please follow the instructions provided in the appliance's Owner's Manual. Before installation, make sure to read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS in the manual to ensure proper installation and operation.
Here are the general steps for installation:
1. Electrical Requirements:
- The washer requires a minimum circuit amperage rating of 15A.
- The maximum ampere draw is 10.36A.
- The operating voltage is 120V AC only.
- The operating frequency is 60Hz.
2. Planning Dimension:
- The product dimensions are provided in inches and millimeters in the manual.
- The height of the washer with feet is 38 5/8 inches (981 mm) minimum and 40 inches (1016 mm) maximum.
- The product width is 27 inches (686 mm).
- The door width is 22 1/4 inches (565 mm).
- The product depth is 32 15/16 inches (837 mm).
- The product depth with the door open is 52 15/16 inches (1345 mm).
- The door height is 22 1/8 inches (562 mm).
- The height to the bottom of the door is 10 inches (254 mm).
- The position of the power cord is 35 5/16 inches (897 mm).
- The power cord length is 72 inches (1829 mm).
- The position of the water inlet valves is 35 5/16 inches (897 mm).
- The position of the drain hose is 8 inches (203 mm).
- The drain hose length is 52 inches (1321 mm).
- The diameter of the drain hose is 1 inch (26 mm).
3. Spacing and Installation:
- The washer has been tested for installation with 0" (0 mm) clearance on the sides. However, it is recommended to allow more space for ease of installation, servicing, and spacing for companion appliances, walls, doors, and floor moldings.
- Add spacing of 1" (25 mm) on all sides of the washer to reduce noise transfer.
- If installing the washer in a closet with a door, top and bottom air openings in the door are required.
For more specific details and instructions, please refer to your appliance's Owner's Manual or the Quick Start Guide provided with your model.
Add New Comment