User Manual Q&AAnswer
Feb 21, 2024 - 01:59 AM
To install the batteries in the Taylor 1730 Wireless Indoor/Outdoor Thermometer and Clock with Remote Sensor, please follow these steps:
1. Base Station: The base station operates on 2 AAA batteries (not included). The battery compartment is located at the back of the station. Remove the battery compartment door. Install (2) AAA size batteries into the battery compartment according to the polarity markings. Replace the battery compartment door.
2. Remote Sensor: The remote sensor operates on 2 AAA batteries (not included). The battery compartment is located at the back of the sensor. Slide off the battery compartment cover. Install (2) AAA size batteries into the battery compartment according to the polarity markings. Replace the battery compartment cover.
3. After Batteries are Installed: When the stations are powered up, the LCD screen on the base station will light up for 3 seconds, then the station will display initial indoor temperature readings. The outdoor temperature display will show dashes "(--)". Press and hold the button on the front of the base station to activate the pairing to obtain outdoor temperature. A transmission signal icon (" ") will flash by the "OUT" temperature digits during this time. When the " " icon turns off, the base station has connected with the remote and starts reporting the current outdoor temperature.
Note: It is important to install the batteries in the base station first, then the remote sensor, to ensure proper connection between the stations. Also, keep the base station and remote close to each other during setup for the best connection.
Add New Comment