User Manual Q&AAnswer
Feb 20, 2024 - 01:35 AM
To adjust the cut depth on the BLACKandDECKER LE750 EdgeHOG 2-in-1 Landscape Edger, follow these steps:
1. Wait for the blade to come to a complete stop and unplug the tool for safety.
2. Locate the cut depth xxxx on the edger. It is usually located near the front wheel.
3. Loosen the cut depth xxxx by turning it counterclockwise.
4. Adjust the front wheel depth to your desired depth using the depth indicator on the wheel bracket and the marking on the front housing. It is recommended to set the depth at 1 inch for edging.
5. Tighten the cut depth xxxx firmly by turning it clockwise.
6. The cut depth is now adjusted to your desired setting.
Note: If the tool slows down during operation, back it up slightly until the blade comes up to normal speed. This may indicate that the cut depth is too deep for the current conditions.
Please refer to the "Cut Depth Adjustment" section in the instruction manual (page 5) for visual references and additional information.
Add New Comment