User Manual Q&AAnswer
Feb 15, 2024 - 12:42 AM
To install the WEST BIKING Wireless Bicycle Computer, follow these steps:
1. Mount the battery: Insert a one-dollar coin into the gap of the battery cover and rotate it counterclockwise to open the battery cover. Insert the battery and cover it up.
2. Install the bracket: Add a rubber slice on the handlebar to fix the bracket on the bicycle handlebar with a ribbon cord.
3. Install the bicycle computer gauge outfit: Insert the gauge outfit into the end along the bracket slot and press the shrapnel to secure it.
4. Install the transmitter: Add rubber slices on the bicycle tube and fix the transmitter with a ribbon cord to the required position. Make sure that the side of the transmitter marked with "SENSOR" is facing the forward magnet.
5. Install the magnet: Disassemble the nut at the bottom of the magnet, fasten the magnet with a xxxx to the spokes of the wheel, and tighten the nut.
Note: The maximum distance between the bicycle computer gauge outfit and transmitter should be 80cm. Adjust the location of the transmitter within this scope. The minimum distance between the transmitter and magnet should be less than 5mm. Adjust the location of the magnet within this scope. The transmitter and gauge outfit should be placed vertically, and the angle should not be over 30°.
For more detailed instructions and illustrations, refer to the WEST BIKING Wireless Bicycle Computer User Manual.
Add New Comment