User Manual Q&AAnswer
Feb 12, 2024 - 02:25 AM
To turn on the Vikeri Trail Camera E2, follow these steps:
1. Open the camera by unlocking the two side locks.
2. Open the battery compartment.
3. Insert 4 or 8 AA 1.5V type alkaline batteries into the slots. Make sure to place them all in the upper or lower half of the battery compartment if you are using only 4 batteries.
4. Insert a Micro SD memory card into the card slot.
5. Set the operating mode switch to ON.
6. The camera will start operating and go into standby mode after 15 seconds.
Please refer to the user manual for more detailed instructions and information on using the Vikeri Trail Camera E2.
Add New Comment