User Manual Q&AAnswer
Jan 26, 2024 - 03:26 AM
To clean the filters of the Shark Navigator Lift-Away Deluxe NV360 Series, follow these steps:
1. Remove the dust cup from the vacuum by lifting the latches on the side.
2. Pull out the pre-motor filters from the top of the pod.
3. Rinse the filters thoroughly in lukewarm water until the water runs clear.
4. Squeeze out excess water and let the filters air-dry for at least 24 hours before replacing them.
5. Place the felt filter in first, then the foam filter.
6. Replace the dust cup on top of the pod, hooking the two latches onto the tabs on the sides and pushing down to lock.
Note: Do not put the filters in the washing machine or dishwasher. Hand wash the filters only with water to prevent damage from cleaning chemicals. Allow all filters to air-dry completely before replacing them in the vacuum to prevent liquid from being drawn into electric parts. Do not use a hair dryer or other heating methods to dry the filters.
For more information and detailed instructions, please refer to the "Maintenance" section of the Shark Navigator Lift-Away Deluxe NV360 Series User Manual.
Add New Comment