User Manual Q&AAnswer
Jan 26, 2024 - 02:57 AM
To connect the MHK2 RedLINK Wireless Remote Controller to the Kumo cloud, you will need to have the Wireless Interface 2 or later installed and configured with the Kumo cloud app. Here are the steps to connect:
1. Install and configure the Wireless Interface 2 or later with the Kumo cloud app following the instructions provided with the interface.
2. Once the Wireless Interface is set up and connected to the internet, ensure that the MHK2 RedLINK Wireless Remote Controller is linked to the Wireless Receiver.
3. On the MHK2 Controller, press and release the CONNECT button. The CONNECT light should start flashing.
4. If the CONNECT light does not flash, it may indicate that another receiver or RedLINK Wireless Receiver is in wireless setup mode. Exit wireless setup on the other device before proceeding.
5. Make sure there is only one unit in wireless setup mode at a time. Press and release the CONNECT button again if necessary.
6. The CONNECT LED on the Wireless Receiver will flash green to indicate it is in wireless setup mode.
7. Once the MHK2 Controller and Wireless Receiver are in wireless setup mode, they will establish a secure connection. The CONNECT LED on the Wireless Receiver will turn solid green when at least one RedLINK device is enrolled onto the receiver.
8. At this point, the MHK2 Controller should be connected to the RedLINK Wireless Receiver. You can now access and control your MHK2 Controller through the Kumo cloud app.
Note: It is important to follow the specific instructions provided with the Wireless Interface 2 or later and the Kumo cloud app for proper setup and configuration.
Add New Comment