User Manual Q&AAnswer
Jan 26, 2024 - 02:52 AM
To assemble the SUNJOE SPX3000-XT1-RM 13A Electric Pressure Washer, please follow these steps:
1. Position the washer as close as possible to the water supply.
2. Slide the trigger gun holder into position.
3. Slide the transport handle into position and secure it with 4 large screws.
4. Assemble the hose holder by sliding it into position and securing it with one small xxxx .
5. Click the detergent bottle with foam cannon and the 4 quick-connect nozzles in place on the nozzle storage board.
6. Assemble the spray wand protector by snapping the tab into the slot located at the bottom left side of the unit and securing it in place with the remaining small xxxx .
7. Fit the stainless steel lance into the trigger gun and rotate the collar until the two parts are completely locked.
8. Connect the high-pressure hose to the trigger gun.
9. Connect the high-pressure hose to the water outlet on the washer.
10. Connect the garden hose adapter (female coupler) to the water inlet of the pressure washer, then thread your garden hose (male end) into the garden hose adapter.
11. Attach a garden hose to the water supply.
12. Make sure the On/Off switch is set to the OFF (0) position before plugging the unit into the power outlet.
13. Check that the electrical supply voltage and frequency (Volt/Hz) correspond to those specified on the pressure washer rating plate. If the power supply is correct, you may now plug the pressure washer into the power outlet.
Please refer to the owner's manual for more detailed instructions and illustrations.
Add New Comment