User Manual Q&AAnswer
Dec 19, 2023 - 01:35 AM
To assemble the Creality Ender-3 3D Printer, follow these steps:
1. Start by installing the Z-axis limit switch kit and Z-axis profiles. Place the endstop sensor on the Z-axis (left) and use four M5X45 screws to fix the Z-axis with the base.
2. Install the Z-axis motor kit and T-type xxxx . Lock the T-shaped xxxx rod on the Z-axis motor component and use two M4X18 screws to slightly lock the Z-axis motor component on the profile.
3. Install the pneumatic joint, XE-axis kit, and synchronous belt. Tighten the tube connector with an open-end wrench. Fix the XE-axis kit with two M4X16 screws. Put the timing belt through the XE-axis kit in the same direction as shown in the manual.
4. Install the extrusion kit and Z-axis passive block. Put the synchronous belt into the profile along the V-wheel of the extrusion kit. Lock the Z-axis passive block with one M4X16 xxxx .
5. Install the X-axis tensioner. Insert the timing belt into the tensioner block and put it into the X-axis tensioner. Tighten it with a plastic hand xxxx nut. Lock it with a round head M4X16 xxxx and a countersunk head M4X14 xxxx on both sides of the Z-axis passive block.
6. Install the Z-axis moving kit. Make the Z-axis moving kit insert the two ends of the Z-axis profile along the V-wheel on both sides.
7. Install the gantry profile and display kit. Install the upper frame of the gantry structure with four M5X25 screws. Use an Allen wrench to lock the screen kit onto the machine with the left side four screws.
8. Install the material rack, gantry cover, and indication xxxx . Put flat round head M5X8 and MST screws into the material rack. Place the spool holder on the rack and fix it on the profile with screws. Put the indication xxxx on the motor shaft and place the 2020 profile cover on both sides.
Once you have completed these steps, your Creality Ender-3 3D Printer should be fully assembled and ready to use. For more detailed instructions and illustrations, please refer to the user manual provided with the printer.
Add New Comment