User Manual Q&AAnswer
Dec 12, 2023 - 01:04 AM
To install the exhaust hose for your Danby Portable Air Conditioner, follow these steps:
1. Attach the air outlet adapter and the window slider adapter onto either end of the exhaust hose.
2. Insert the air outlet adapter into the back of the appliance by placing it over the air exhaust and then pushing it in the direction of the arrow to lock it into place.
3. Measure the window opening where the window kit will be installed. Assemble as many sliders as necessary to fit the window. If the length of the window requires all three sliders, use two bolts to fasten the sliders at the correct length. If the window opening is less than the minimum length of a single slider, use the slider that has the hole in it and cut it to the correct length. Make sure not to cut the end that has the hole as this is necessary to attach the exhaust hose adapter.
To install the window kit:
1. Cut the adhesive foam seals A and B to the correct length for the window. Attach them to the window sash and frame as shown in the manual.
2. Insert the assembled window slider kit into the window opening.
3. Cut the non-adhesive foam seal C to match the width of the window. Insert the foam seal between the glass and the window frame to prevent air and insects from getting into the room.
4. Attach the window slider adapter to the hole in the window slider kit.
Note: It may be easier to attach the window slider adapter to the window slider kit before placing the kit in the window. Also, make sure not to overextend or bend the hose as this will impede air flow.
For visual instructions, you can refer to the video provided in the manual.
Please note that proper installation of the exhaust hose is important for the efficient operation of your portable air conditioner.
Add New Comment