Answer
Dec 07, 2023 - 09:30 PM
Sure! Here are the step-by-step instructions for installing the Hisense Air Conditioner:
1. Read the installation section of the user manual carefully before starting the installation process.
2. Choose a suitable location for installing the indoor unit. Make sure there are no obstacles near the air outlet and that air can be easily blown to every corner of the room. Also, ensure that the required space from the unit to the ceiling and wall is maintained.
3. Drill a hole on the wall for the pipe and install a sleeve to keep the wall tidy and clean.
4. Connect the pipes and cables through the wall hole from either the inside or outside, depending on the location of the indoor unit.
5. Install the mounting plate for the indoor unit on the wall. Make sure it is horizontal and securely fixed with screws.
6. Connect the power cord to the indoor unit by connecting the wires to the terminals on the control board. Refer to the wiring diagram in the manual for the correct connections.
7. Install the drain port and drain hose for the outdoor unit, if applicable. This will direct the condensate water away from the unit.
8. Install and fix the outdoor unit on a flat and strong surface. Make sure it is securely fixed to prevent shaking due to vibration or strong wind.
9. Connect the pipes to the 2-way and 3-way valves on the outdoor unit. Tighten the connections according to the required torque.
10. Connect the power cord to the outdoor unit by connecting the wires to the terminals on the control board. Secure the power cord with a cable clamp.
11. Purge the air from the refrigerant cycle using a vacuum pump. This will remove any air and moisture from the system.
12. Once the installation is complete, check all connections for tightness and make sure there are no leaks. Test the air conditioner to ensure it is working properly.
Please note that these are general installation instructions. It is important to refer to the specific instructions provided in the Hisense Air Conditioner User Manual for your model.
Add New Comment